Physicochemical and technological properties of beef burger as influenced by the addition of pea fibre

This study aimed to evaluate the physicochemical characteristics and sensory attributes of beef burgers with the addition of pea fibre as a partial substitute of meat or fat. Three formulations were prepared: control (CON) – similar to the commercial formulation; fibre/less meat (FLM)—5% meat reduction and addition of 1% pea fibre; fibre/less fat (FLF)—7% fat reduction and addition of 1% pea fibre. Non-significant differences were obtained for pH, colour parameters (L* and b*), texture profile, cooking loss and size reduction among formulations. Moreover, sensory analysis with consumers of beef burgers did not indicate differences among the formulations for all the analysed attributes. Therefore, pea fibre is a promising partial replacer for meat and fat in beef burgers due to the preservation of technological parameters and sensory acceptance.     

硫酸铵法利用中低品位锂瓷土矿制备碳酸锂技术研究

针对江西宜丰地区氧化锂质量分数<2.0%以下中低品位锂瓷土矿,研究了硫酸铵法提取碳酸锂技术路线。首先,利用二步焙烧工艺,有利于脱氟、提高锂浸出率,并且能够有效防止结窑现象发生。在浸出液除杂过程中,采用成矾除铝的方法将大量溶出的铝离子转变为KAl（SO₄）₂·12H₂O、NH₄Al（SO₄）₂·12H₂O等有价值复盐,规避了传统石膏法产生的大量固废,有70%的铝离子被转变为矾盐晶体,同时带出大量的结晶水,减轻后续浓缩压力,对比传统的石膏法产生大量固废而言,其优点是显而易见的。碳化反应产品的XRD以及氧化锂含量分析表明,碳酸锂的纯度达到99%以上,全程锂收率为50%~60%。作为提锂实验对比,采用宜春414矿锂质量分数为4.0%的锂云母,由于414矿样中铝的相对含量更低,导致相同的除杂难度下得到的414矿样中浸出液锂离子浓度更高,浓缩倍数更小,414矿样的锂回收率更高。实验结果表明,中低品位锂瓷土提锂的工艺规律,通过适当改变参数,能够应用于难度更低的高品位的锂云母提锂过程。     

煤磨热风管道改造的效果

中联万基水泥有限公司4500t/d熟料生产线采用SCLW4-12×13.4第四代篦冷机,煤磨热风取风口和余热发电AQC热风取风口在篦冷机同一对称位置,煤磨与余热发电系统存在争风现象,开停煤磨对余热发电系统影响较大。通过从废气管道处开孔,加装管道和电动阀,与热风管道汇合通往煤磨沉降室,调整相应阀门开度,可以控制入煤磨烟气温度,这样不但提高了余热发电量,而且提高了煤磨产量,同时也降低了窑头排风机的负荷,降低了熟料生产电耗。     

Erbium doped Bi2O3-B2O3 glass-ceramics containing Bi3B5O12 and CaF2 nanocrystallites for 1.53 μm fiber lasers

Trivalent erbium ions doped Bi₂O₃-B₂O₃ transparent glass ceramics containing CaF₂ were prepared and characterized through X -ray diffraction, scanning electron microscopy, Fourier transform infrared absorption, optical absorption, and near infrared emission for 1.53 μm fiber lasers. The glass ceramics obtained by applying thermal treatment at 575 °C for 5 h and 575 °C for 10 h contain Bi₃B₅O₁₂ and CaF₂ crystallites. The Judd-Ofelt theory was applied to evaluate various spectroscopic and laser characteristic properties. The NIR emission corresponding to the ⁴I_13/2 → ⁴I_15/2 (∼1.53 μm) transition was studied by exciting the samples at 514.5 nm laser radiation. The stimulated emission cross-sections of ∼1.53 μm luminescence were also obtained applying the Mc Cumber theory. The experimental results confirm that the transparent glass ceramic obtained at a thermal treatment of 575 °C for 10 h is more suitable to design fiber lasers for diverse applications in the fields of industry, medicine and scientific research.     

纵轴式掘进机截割头载荷影响因素的仿真分析

针对现有掘进机截割头载荷特性研究方法采用单一影响因素不能全面反映截割头载荷及其波动变化规律的问题,通过分析截割头瞬时载荷,确定了纵轴式掘进机在水平截割工况下截割头载荷的主要影响因素有截割岩石特性、截割头掏槽深度、截割头吃刀深度、截割头转速和截割臂摆速。针对某纵轴式掘进机水平截割工况,采用Matlab对影响截割头载荷的多种因素进行仿真分析,得到了各向载荷及其波动随各因素的变化规律:截割头载荷随着岩壁普氏系数的增大而增加,其中横向阻力增加尤为明显,横向阻力波动程度高于其他方向载荷,且随着岩壁普氏系数的增大呈减小趋势;随着截割头掏槽深度的增加,截割头各向载荷近似呈线性增加,其中升力增加幅度最大,各向载荷波动则随着截割头掏槽深度的增大而减小;随着吃刀深度的增加,截割头载荷总体呈增大趋势,载荷波动程度则随之减小;在截割头转速一定的情况下,截割头载荷均随着截割臂摆速的增加而增大,在同一摆速下,截割头载荷随着截割头转速的减小而增大,横向阻力波动明显高于升力和推进阻力波动,横向阻力和推进阻力波动按截割头载荷规律变化,升力波动则与之相反。截割头载荷波动变化规律与截割头载荷变化规律不尽一致,有时甚至相互冲突。因此,掘进机作业过程中应合理选择截割头掏槽深度、吃刀深度等操作参数和截割头转速、截割臂摆速等运动参数,使各参数相互匹配,以减小掘进机振动,延长使用寿命。     

Novel Gemini Cationic Surfactants: Thermodynamic,Antimicrobial Susceptibility,and Corrosion Inhibition Behavior against Acidithiobacillus ferrooxidans

The Egyptian oil and gas industry is suffering from severe metal corrosion problems, particularly microbial-induced corrosion. There is limited knowledge on the corrosion inhibition of carbon steels in the presence of an acidophilic, iron-oxidizing bacterial species Acidithiobacillus ferrooxidans. Therefore, in this study, novel Gemini cationic surfactants, in three forms depending on variation in alkyl chains of 8, 12, and 16 carbon atoms named FHPAO, FHPAD, and FHPAH, respectively, were synthesized and characterized by Fourier transform infrared and nuclear magnetic resonance spectroscopy. The surface parameters and the thermodynamic of the synthesized surfactants were evaluated at three different temperatures, 20, 40, and 60 °C. The synthesized Gemini cationic surfactants were tested as broad-spectrum antimicrobial, antibacterial and anticandida agents. They evaluated as biocides and corrosion inhibitors against Acidithiobacillus ferrooxidans. FHPAD showed higher adsorption ability at the solution interface and higher affinity to construct micelles than FHPAO and FHPAH. Both adsorption and micellization processes were hydrophobic and temperature dependent. FHPAO, FHPAD and FHPAH exhibited wide-spectrum antimicrobial activities, and the highest activity and the lowest minimum bactericidal/fungicidal inhibitory concentrations were attributed to FHPAD. Furthermore, synthesized FHPAD demonstrated the highest metal corrosion inhibition efficiency of 95.5% at 5 mM in comparison to 87.5% and 81.7% for FHPAO and FHPAH, respectively. In conclusion, this study provides novel synthesized cationic surfactants with many applications in the oil and gas industry, such as broad-spectrum antimicrobial, biocides, and corrosion inhibitors for acidophilic, iron-oxidizing bacterial species Acidithiobacillus ferrooxidans.     

涡流空气分级机熵产与分级性能分析

利用热力学第二定律中的熵产理论对涡流空气分级机各不可逆因素引起的熵产进行分析，通过粉料分级试验对其分级性能进行验证，获得了黏性熵产、湍流熵产和壁面熵产分布特点及操作参数对熵产和分级精度的影响规律。熵产分析结果表明，涡流空气分级机内湍流熵产和壁面熵产占总熵产的比例高达56.41%和43.11%，湍流熵产主要产生于转笼叶片间和转笼内部，进风口和细粉出口壁面剪切引起较大壁面熵产；此外，转笼转速和进口风速变化分别仅对转笼区域和切向进风口区域内气流运动熵产影响较大，进口风速-转笼转速处于8.6m/s、 800r/min和18m/s、1200r/min操作工况附近时，涡流空气分级机内总熵产/总能变化率较小，分级流场稳定性较高，对粗、细颗粒分离有利，该工况下分级机的粉料分级试验效果较好，说明熵产理论可用于涡流分级机内流动分析及其操作参数的优化匹配。     

[数据驱动的产品设计]基于功能模型和层次分析法的智能产品服务系统概念方案构建

为研究智能产品服务系统概念方案的构建，解决系统的复杂特性和功能耦合特性，提出应用发明问题解决理论（TRIZ）功能模型和层次分析法(AHP)两种工具，在概念设计阶段利用TRIZ功能模型定性地对其进行分析建模，并借助层次分析法对不同服务供应商所提供的服务功能模块进行定量的决策分析，通过择优集成相关功能模块，形成智能产品服务系统概念方案的构建方法。最后以3家服务供应商的服务功能模块构建为例，验证该方法的有效性。     

计及RSC控制的DFIG短路电流直流分量解析表达

现有文献针对计及转子变流器(RSC)控制的双馈感应风电机组(DFIG)定子短路电流解析表达,将定子磁链当作一阶直流衰减分量或忽略功率外环控制。基于DFIG电压、磁链和RSC控制方程,得到定子电流关于定子电压和定子功率的传递函数,提出定子电流的精确解析表达式。基于RSC内、外环PI参数关系,推导直流分量衰减时间常数和角频率关于PI参数的表达式。分析了RSC内外环PI参数对定子电流直流衰减分量的影响。仿真结果验证了解析表达式的准确性,为PI参数选取和保护装置测量、整定提供依据。     

汽车涂装废水处理技术的研究进展

汽车涂装中产生大量的工业废水，主要包括脱脂废水、磷化废水、电泳废水和喷漆废水等,其典型污染物为重金属离子、表面活性剂、油漆颗粒、磷酸盐等，是一类复杂及难处理的高浓度工业废水。依据废水中所含污染物的不同，对涂装各工序废水进行分质预处理可有效地去除磷酸盐、重金属离子、悬浮固体、油类物质等污染物，有利于减轻后续生物或高级处理单元的负荷，提高整个处理系统的效率。本文综述近年来汽车涂装废水处理方面的研究成果或实践，旨在总结预处理工艺及主体处理工艺的优点及存在的不足，希望为汽车涂装废水处理达标排放及循环回用提供一些借鉴。